3
• Turn off the gas immediately if a gas smell is detected. Turn cylinder valve
OFF
. If the leak is at the hose/regulator connection tighten the
connection and perform another leak test. If bubbles continue appearing contact your supplier. If the leak is at the regulator/cylinder connection
disconnect from cylinder, reconnect and perform another leak check. If soap bubbles are still seen, cylinder valve is defective. Return cylinder to
its place of purchase.
• Keep the ventilation opening of the cylinder enclosure free and clear of debris.
•
DO
NOT
paint the radiant screen, control panel or top canopy reflector.
• Control compartment, burner and circulation air passageways of the heater must be kept clean.
• Turn off gas whilst not in use.
•
LP
regulator/hose assembly must be a protected from accidental damage.
• Any guard removed for servicing/maintenance must be replaced before operation.
• Keeps adults and children away from the high temperature surfaces, to avoid burns and ignition of clothing.
• Children should be carefully supervised when they are in the vicinity of the heater.
•
DO
NOT
hang clothing or other flammable materials on the heater or place them near the heater.
Heater Stand and Location
• The heater is primarily for outdoor use only. Always ensure that adequate fresh air ventilation is provided.
•
Always maintain proper clearance to non protected combustible materials i.e. top 100 cm and sides 100 cm minimum.
•
Heater must be placed on level firm ground.
•
Never operate heater in an explosive atmosphere like in areas where gasoline or other flammable liquids or vapours are stored.
• To protect heater from strong wind, anchor the base securely to the ground with screws.
• Gas Requirements
• This heater is primarily designed to be used with propane gas.
• Butane gas may also be used with the appropriate regulator however butane freezes at zero degrees so will not be ideal to be used during cold
temperatures.
• A dented, rusted or damaged cylinder may be hazardous and should be checked by your gas supplier before being used with this heater.
• Never connect an unregulated cylinder to the heater.
Contents
(Model No. DG10001; 37mbar)
