dellonda baridi DH72, Руководство пользователя

Страница: 11 / 28

11
• USING YOUR DISHWASHER
NOTE!
If your model has no water softener, you can skip to the next section.
Loading the salt into the softener
• Always use salt intended for use with dishwasher.
• The salt container is located beneath the basket and should be filled as follows:
• A. Remove the basket and then unscrew and remove the cap from the salt container.
• B. Before first wash, add 1lt of water in the salt container of your machine.
• C. Place the end of the funnel (if supplied) into the hole and introduce about, 0.13kg of salt. It is
normal for a small amount of water to come out of the salt container.
• D. After filling the container, screw the cap tightly back clockwise.
• E. Usually, the salt warning light will be cease to be illuminated within 2-6 days check the salt
container has been filled with salt.
• F. Immediately after filling the salt into the salt container, a washing programme should be started
(Suggest choose rapid program). Otherwise filter system, pump or other important parts of the
machine may be damaged by salty water. This will not be covered by the warranty.
Adjusting the salt consumption
• Step 1: Enter the status of salt adjustment Close the door, within 60 seconds after power on, press
button and hold for 5 seconds, the machine will enter setting mode
• Step 2: select a certain level of salt consumption. Press the button to select the proper setting
according to your local environment, the sets will change in the following sequence: H1->H2->H3-
>H4->H5->H6.
• Step 3: Exit the status of salt adjustment. Without any operation in five seconds, the machine will
exit from set mode, the machine is into standby mode.
• There are 6 levels of salt consumption in all. It is recommended to select the level according to
below table:
NOTE!
The salt container must only be refilled when the salt warning light in the control panel
comes on. Depending on how fully the salt dissolves, the salt warning light may still be on even
though the salt container is filled.
If there is no salt warning light in the control panel (For some Models), you can judge when to
load the salt into the softener by the cycles that the dishwasher had run. If there are spills of the
salt, a soak or a rapid program should be run to remove the excess salt.