Dell XPS M1210, Руководство пользователя, Страница: 94 / 192

94
Troubleshooting
M EMORY WRITE / READ FAILURE AT ADDRESS , READ VALUE EXPECTING VALUE —
A memory module may be
faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them (see "Memory"
on page 119).
N O BOOT DEVICE AVAILABLE —
The computer cannot find the hard drive. If the hard drive is your boot
device, ensure that the drive is installed, properly seated, and partitioned as a boot device.
N
O BOOT SECTOR ON HARD DRIVE
—
The operating system may be corrupted. Contact Dell. See
"Contacting Dell" on page 141.
N O TIMER TICK INTERRUPT —
A chip on the system board may be malfunctioning. Run the System Set
tests in the Dell Diagnostics (see page 85).
N OT ENOUGH MEMORY OR RESOURCES . E XIT SOME PROGRAMS AND TRY AGAIN —
You have too many
programs open. Close all windows and open the program that you want to use.
O
PERATING SYSTEM NOT FOUND
—
Reinstall the hard drive (see "Hard Drive" on page 116). If the problem
persists, contact Dell. See "Contacting Dell" on page 141.
O PTIONAL R O M BAD CHECKSUM —
The optional ROM apparently failed. Contact Dell. See "Contacting
Dell" on page 141.
A REQUIRED . D L L FILE WAS NOT FOUND —
The program that you are trying to open is missing an essential
file. Remove and then reinstall the program.
1
Click the Start button and click Control Panel .
2
Click Add or Remove Programs .
3
Select the program you want to remove.
4
Click Remove or Change/Remove and follow the prompts on the screen.
5
See the program documentation for installation instructions.
S ECTOR NOT FOUND —
The operating system cannot locate a sector on the hard drive. You may have a
defective sector or corrupted FAT on the hard drive. Run the Windows error-checking utility to check the
file structure on the hard drive. See the Windows Help and Support Center for instructions. To access
the Help and Support Center, see "Windows Help and Support Center" on page 13. If a large number of
sectors are defective, back up the data (if possible), and then reformat the hard drive.
S
EEK ERROR
—
The operating system cannot find a specific track on the hard drive.
S
HUTDOWN FAILURE
—
A chip on the system board may be malfunctioning. Run the System Set tests in
the Dell Diagnostics (see page 85).
T IME - OF - DAY CLOCK LOST POWER —
System configuration settings are corrupted. Connect your computer
to an electrical outlet to charge the battery. If the problem persists, try to restore the data by entering the
system setup program. Then immediately exit the program. See "Using the System Setup Program" on
page 171. If the message reappears, contact Dell.
See "Contacting Dell" on page 141.
T IME - OF - DAY CLOCK STOPPED —
The reserve battery that supports the system configuration settings may
require recharging. Connect your computer to an electrical outlet to charge the battery. If the problem
persists, contact Dell. See "Contacting Dell" on page 141.