5. Disassembly and Assembly Procedures
S16
S14
S17
(No.1 screw size=M3x3, Torque=3.5
±
0.5
kgfxcm;
No.2~3 screw size=M3x4, Torque=1
±
0.2kgfxcm)
Take 1pcs USB board, 1pcs USB connective cable
and 1pcs USB bracket. Connect the USB cable to
the connector of the USB board, and then locate the
USB board into the USB bracket and use a
Philips-head screwdriver to tighten 1pcs screw for
locking the USB board with the bracket. Take 1pcs
USB hub cover to assemble with the USB bracket,
then use a Philips-head screwdriver to tighten 2pcs
screws for locking the cover with the whole unit.
(No.1~7 screw size=M3x6, Torque=4
±
1
kgfxcm)
Locate the right speakers into the provers of the
middle frame, then connect the LED cable, USB
connective cable and speaker’s cable to the
connectors of the board. Use a Philips-head
screwdriver to tighten 7pcs screws for locking the
two speakers with middle frame.
1
3
2
(No.1~4 screw size=M3x4, Torque=3.5
±
0.5kgfxcm)
Locate the USB unit to the hooks of middle frame,
then use a Philips-head screwdriver to tighten 4pcs
screw for locking the USB unit with the middle frame.
S15
3
2
1
4
3
2
1
6
5
7
4
Take 1pcs joystick key, 1pcs joystick board and 1pcs
rear cover, then assemble the joystick key with the
board, then paste 1pcs conductive foam on the back of
the board. Locate the joystick board to the correct
position of the rear cover, then use a Philips-head
screwdriver to lock 2pcs screws for locking the joystick
board with rear cover. Tear off the papers on the back
of the cable, and then fix the joystick cable with tapes.
(No.1~2 screw size=M2x2.4,Torque=1
±
0.2kgfxcm)
1
2
