Back to Contents Page
Hard Drive(s)
Dell Studio™ 1745/1747 Service Manual
Removing the Hard Drive(s)
Replacing the Hard Drive(s)
Removing the Hard Drive(s)
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the base cover (see
Removing the Base Cover
).
4.
Remove the hard drive(s) from the computer base.
l
For hard drive 1:
¡
Remove the four screws that secure the hard drive assembly to the computer base.
¡
Using the pull-tab, slide the hard drive towards the left to disconnect the hard drive assembly from the connector on the system board.
¡
Lift the hard drive assembly out of the computer base.
¡
Remove the four screws that secure the hard drive cage to the hard drive.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To prevent data loss, turn off your computer (see
Turning Off Your Computer
) before removing the hard drive. Do not remove the hard
drive while the computer is On or in Sleep state.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Hard drives are extremely fragile. Exercise care when handling the hard drive.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
NOTE:
If you are installing a hard drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new hard
drive (see the
Dell Technology Guide
).
CAUTION:
When the hard drive is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge"
in the safety instructions that shipped with your computer).
1
pull-tab
2
hard drive assembly
3
screws (4)
Содержание Studio 1745
Страница 5: ...Back to Contents Page ...
Страница 9: ...Back to Contents Page ...
Страница 47: ...15 Reinstall any removed cards in the ExpressCard slot or the 8 in 1 media card reader Back to Contents Page ...
Страница 59: ......