Dell Sonicwall Sonicpoint Ace, Руководство по началу работы

Страница: 44 / 53

42 |
Safety and regulatory
information
Mounting the appliance
• Mount in a location away from direct sunlight and
sources of heat. A maximum ambient temperature of
104º F (40º C) is recommended.
• Route cables away from power lines, fluorescent
lighting fixtures, and sources of noise such as radios,
transmitters, and broadband amplifiers
• The included power cord(s) are approved for use only
in specific countries or regions. Before using a power
cord, verify that it is rated and approved for use in
your location.
• Ensure that no water or excessive moisture can enter
the unit.
• Allow unrestricted airflow around the unit and through
the vents on the side of the unit. A minimum of 1 inch
(25.44mm) clearance is recommended.
• Consideration must be given to the connection of the
equipment to the supply circuit and the effect of
overloading the circuits has minimal impact on
overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings must be
used when addressing this concern.
Cable connections
All Ethernet and RS232 (Console) cables are designed for intra-
building connection to other equipment. Do not connect these
ports directly to communication wiring or other wiring that
exits the building where the appliance is located.
Power supply information for
APL26-0AE
If the power supply is missing from your Dell SonicWALL
product package, contact Dell SonicWALL Technical Support at
https://support.software.dell.com/manage-service-request
for a
replacement. This product should only be used with a UL
listed power supply marked “Class 2” or “LPS”, with an output
rated 48 VDC, minimum 0.35 A, Tma: minimum 40 degrees C.
If power is provided by the Ethernet cable plugged into the
“lan” port, this is called “Power Over Ethernet” or “POE.” The
POE source should only be UL listed marked “Class 2” or
Regulatory Model/Type Product Name
APL26-0AE SonicPoint-ACe
SonicPoint_ACe_GSG.book Page 42 Monday, September 29, 2014 5:23 PM
Draft
Document