Dell S6100, Руководство по настройке

Страница: 243 / 1743

Standard MAC ACL Commands
When you create an access control list without any rule and then apply it to an interface, the ACL behavior reflects implicit permit. These
commands configure standard MAC ACLs and support both Ingress and Egress MAC ACLs.
NOTE: For more information, also refer to the Commands Common to all ACL Types and Common MAC Access List Commands
sections.
deny
To drop packets with a the MAC address specified, configure a filter.
Syntax deny {any | mac-source-address [ mac-source-address-mask ]} [count [byte]] [log]
[monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s sequence number.
• Use the
no deny {any | mac-source-address mac-source-address-mask }
command.
Parameters
any Enter the keyword
any
to specify that all routes are subject to the filter.
mac-source-
address Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified,
a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC
addresses that match).
count (OPTIONAL) Enter the keyword
count
to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword
byte
to count bytes processed by the filter.
log (OPTIONAL, E-Series only) Enter the keyword
log
to log the packets.
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is describing the traffic that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface. For more information, see the “Flow-based Monitoring” in the Port
Monitoring section in the
Dell Networking OS Configuration Guide .
Defaults Not enabled.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Access Control Lists (ACL) 243