•
permit icmp (for Extended IP ACLs)
•
permit udp (for Extended IP ACLs)
•
•
permit (for Standard MAC ACLs)
•
•
permit tcp (for Extended IP ACLs)
•
seq arp (for Extended MAC ACLs)
•
seq ether-type (for Extended MAC ACLs)
•
•
•
•
•
•
•
deny arp (for Extended MAC ACLs)
•
deny icmp (for Extended IPv6 ACLs)
•
•
deny udp (for Extended IP ACLs)
•
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specific options. Some commands in this chapter may
use similar names, but require different options to support the different ACL types (for example, the
deny
and
permit
commands).
remark
Enter a description for an ACL entry.
Syntax
remark [
remark-number
] [
description
]
Parameters
remark-number
Enter the remark number. The range is from 0 to 65535 for MAC ACL and 0 to
4294967290 for IP ACL.
NOTE:
You can use the same sequence number for the remark and an ACL
rule.
description
Enter a description of up to 80 characters.
Defaults
Not configured.
Command Modes
•
CONFIGURATION-STANDARD-ACCESS-LIST
•
CONFIGURATION-EXTENDED-ACCESS-LIST
•
CONFIGURATION-MAC ACCESS LIST-STANDARD
•
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
180
Access Control Lists (ACL)
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...