Dell S3048-ON, Руководство по настройке

Страница: 713 / 1036

Example of a Failed Authentication
To view the configuration, use the
show config
in LINE mode or the
show running-config
command in EXEC Privilege
mode.
If authentication fails using the primary method, Dell Networking OS employs the second method (or third method, if necessary)
automatically. The fallback to the second method would happen only if the authentication failure is due to a non-reachable server or invalid
TACACS server key. The fallback would not occur if the authentication failure is due to invalid credentials. For example, if the
server is reachable, but the server key is invalid, Dell Networking OS proceeds to the next authentication method. In the following example,
the is incorrect, but the user is still authenticated by the secondary method.
First bold line: Server key purposely changed to incorrect value.
Second bold line: User authenticated using the secondary method.
Dell(conf)#
Dell(conf)#do show run aaa
!
aaa authentication enable default enable
aaa authentication enable LOCAL enable
aaa authentication login default local
aaa authentication login LOCAL local
aaa authorization exec default none
aaa authorization commands 1 default none
aaa authorization commands 15 default none
aaa accounting exec default start-stop
aaa accounting commands 1 default start-stop
aaa accounting commands 15 default start-stop
Dell(conf)#
Dell(conf)#do show run
!
tacacs-server key 7 d05206c308f4d35b
tacacs-server host 10.10.10.10 timeout 1
Dell(conf)# tacacs-server key angeline
Dell(conf)#%RPM0-P:CP %SEC-5-LOGIN_SUCCESS: Login successful for user admin on
vty0 (10.11.9.209)
%RPM0-P:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable password
authentication success on vty0 ( 10.11.9.209 )
%RPM0-P:CP %SEC-5-LOGOUT: Exec session is terminated for user admin on line
vty0 (10.11.9.209)
Dell(conf)#username angeline password angeline
Dell(conf)#%RPM0-P:CP %SEC-5-LOGIN_SUCCESS: Login successful for user angeline
on vty0 (10.11.9.209)
%RPM0-P:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable password
authentication success on vty0 ( 10.11.9.209 )
Monitoring
To view information on transactions, use the following command.
•
View transactions to troubleshoot problems.
EXEC Privilege mode
debug
Remote Authentication
The system takes the access class from the server. Access class is the class of service that restricts Telnet access and packet
sizes.
If you have configured remote authorization, the system ignores the access class you have configured for the VTY line and gets this access
class information from the server. The system must know the username and password of the incoming user before it can fetch
Security 713