4. Disassembly and Assembly Procedures
Put the bracket chassis module on the back of panel
module, then connect the panel lamp power to the
connector of the panel module. Stick 2pcs conductive
on the specific position of the panel.
S6
Move the front bezel with function key board close to
the panel module, lift up the panel and assemble
front bezel unit with the panel module. Use a Philips-
head screwdriver to tighten 1pcs screw for locking
front bezel with panel module.
(No.1 screw size=M3x4, Torque=3
±0.5
kgfxcm)
S8
Take 1pcs front bezel, 1pcs power key lens, 1pcs
function key lens, assemble the power key lens and
function key lens to the correct positions of the front
bezel. Take 1pcs function key board, assemble the
function key board with the front bezel to through the
hole of the front bezel. Take a fixture to locate the
front bezel with the function key board, then use a
Philips-head screwdriver to tighten 3pcs screws for
locking the function key board with front bezel, then
stick a mylar tape to cover the function key board.
(No.1~3 screw size=M0.2x2.4, Torque=1
±0.2
kgfxcm)
S7
Use a Philips-head screwdriver to tighten 3pcs
screws for locking bracket with panel module, then
use a proper tool to connect the LVDS cable, panel
lamp cable and function key cable to the connectors
of the main board.
(No.1~3 screw size=M3x2.8, Torque=3
±0.5
kgfxcm)
S9
3
2
1
5
2
3
4
1
3
2
1
Adjust the bracket to make it with the panel module
firmly attachment. Use a Philips-head screwdriver to
tighten 4pcs screws for locking bracket with front
bezel and panel module.
(No.2~5 screw size=M3x4, Torque=3
±0.5
kgfxcm)
S10
