4. Disassembly and Assembly Procedures
Take a hinge cover to assemble it with the hinge, then
use a Philips-head screwdriver to tighten 2pcs screws
for locking the hinge cover with the hinge. Take a
stand to assemble with the hinge, then use a Philips-
head screwdriver to tighten 2pcs screws for locking
the stand with the hinge.
(No.1~2 screw size=M2x0.4x3.2, Torque=2
~3
kgfxcm;
No.3~4 screw size=M3x11, Torque=7.5
±
0.5kgfxcm)
S14
Use a Philips-head screwdriver to tighten 2pcs screws
for locking the front bezel with the panel module.
(No.1~2 screw size=M1.6x2.2, Torque=0.5
±
0.1kgfxcm)
S11
Stick 1pcs aluminum foil to cover the LVDS
connector, then stick 1pcs aluminum foil on the
specific position to fix the bracket chassis module.
Tear off 2pcs protective papers of double-faced tapes
on the left-top and right-top of the middle bezel as the
picture below shown.
S12
3
4
Take a rear cover, tear off the gum on the inside of
the rear cover, put down
the
rear
cover
on
the
assembled
unit
carefully and push the rear cover on
the positions marked for two parts engagement.
S13
1
2
1
2
1
2
3
Take a base to assemble it with stand, then use a
Philips-head screwdriver to tighten 3pcs screws for
locking the stand with base. Take 1pcs decoration
strip, tear off the adhesive paper and stick it on the
correct position as the picture below shown.
(No.1~3 screw size=M4x8, Torque=11
±
0.5kgfxcm)
S15
