Dell Precision Compact 3260, Руководство по обслуживанию

Страница: 58 / 93

Steps
1. Ensure that the release lever on the processor socket is fully extended in the open position.
NOTE: The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the processor
socket. When the processor is properly seated, all four corners are aligned at the same height. If one or more corners of
the processor are higher than the others, the processor is not seated properly.
2. Align the notches on the processor with the tabs on the processor socket and place the processor in the processor socket.
CAUTION: Ensure that the processor-cover notch is positioned underneath the alignment post.
3. When the processor is fully seated in the socket, pivot the release-lever down and place it under the tab on the processor
cover.
Next steps
1. Install the heat sink .
2. Install the processor fan .
3. Install the side cover .
4. Follow the procedure in after working inside your computer .
System board
Removing the system board
Prerequisites
1. Follow the procedure in before working inside your computer .
2. Remove the side cover .
3. Remove the hard-drive assembly .
4. Remove the wireless card .
5. Remove the speaker .
6. Remove the processor fan .
7. Remove the processor .
8. Remove the memory modules .
9. Remove the riser card .
10. Remove the solid-state drive .
11. Remove the optional I/O module .
12. Remove the heat sink .
13. Remove the interposer module .
14. Remove the internal antenna
About this task
The following image indicates the connectors on your system board.
58 Removing and installing components