Safety Instructions: Dell PowerVault 35F User's Guide
file:///C|/Users/rishi_sood/Desktop/35F/ug/safety.htm[3/21/2013 11:16:17 AM]
Back to Contents Page
Safety Instructions: Dell PowerVault 35F User's Guide
Alert Messages
|
Laser Safety
|
Product Information
Alert Messages
WARNING: A WARNING denotes a hazard that can cause personal injury.
CAUTION: A CAUTION denotes a hazard that can cause hardware or software damage.
NOTE: A NOTE denotes information that might be of special interest. A note can point out exceptions to
rules or procedures.
Grounding
This product is a Safety Class 1 product and has a protective earthing terminal. There must be an uninterruptible safety
earth ground from the main power source to the product’s input wiring terminals, power cord, or supplied power cord
set. Whenever it is likely that the protection has been impaired, disconnect the power cord until the ground has been
restored.
Servicing
Any servicing, adjustment, maintenance, or repair must be performed only by authorized service-trained personnel.
There are no operator serviceable parts in this product.
Warranty
If you have any questions about the warranty of this product, contact a Dell sales representative.
Laser Safety
Certification and Classification Information
This product uses Gigabit Interface Converters (GBIC) to interface with Fibre Channel links. Optical GBICs shipped
with this product contain internal lasers. In the USA, all optical GBICs shipped with this unit are certified as Class 1
laser products and conform to the requirements contained in the Department of Health and Human Services (DHHS)
regulation 21 CFR Subchapter J.
Outside the USA, all GBICs are certified as Class 1 laser components that conform to the requirements contained in
the International Electrotechnical Commission (IEC) standard 825 (1994) and Amendment 1 (1990) along with the
CENELEC (European Committee for Electrotechnical Standardization) European Normalization standard EN 60825
(1992).
If other then the shipped optical GBICs are used with this product then the user is required to insure that the optical
