M i c r o p r o c e s s o r U p g r a d e I n s t a l l a t i o n G u i d e
1-3
5
Pull the microprocessor socket release lever upward to the fully open position (see
Figure 1-2).
F i g u r e 1 - 2 .
R e m o v i n g a n d R e p l a c i n g t h e M i c r o p r o c e s s o r
NOTICE:
Be careful not to bend any of the pins when removing the microprocessor. Bending
the pins can permanently damage the microprocessor.
6
Lift the microprocessor out of the socket and leave the release lever in the open
position so that the socket is ready for the new microprocessor (see Figure 1-2).
7
Unpack the new microprocessor.
If any of the pins on the microprocessor appear bent, see "Getting Help" in your
Installation and Troubleshooting Guide
for instructions on obtaining technical
assistance.
8
Ensure that the microprocessor socket release lever is in the fully open position.
9
Align pin 1 on the microprocessor (see Figure 1-2) with pin 1 on the microprocessor
socket.
NOTE:
No force is needed to install the microprocessor in the socket. When the
microprocessor is aligned correctly, it should drop into the socket.
pin-1 locators
microprocessor
microprocessor socket
release lever
(open position)
1W371bk2.book Page 3 Tuesday, December 17, 2002 1:02 PM
