Dell PowerEdge 1655MC, Руководство по настройке системы

Страница: 12 / 223

1-8
S y s t e m C o n f i g u r a t i o n G u i d e
www
.dell.com | support.dell.com
F i g u r e 1 - 4 . N e t w o r k S w i t c h M o d u l e
You can configure the network switch module either through the serial port on the system
management module or by using the RJ11 serial null modem cable connected to the RJ11
serial port on the network switch module. A DB9–to–RJ11 cable is provided with the
network switch. Dell recommends using the serial port on the system management module
to configure the network switch module.
NOTE:
Do not connect the RJ11 configuration port to a data or telephone network. Do
not connect the RJ11 serial cable to any of the 10/100/1000 BASE-T uplink ports.
To configure the network switch module using the serial port on the system management
module, perform the following steps:
1
Perform steps 1 through 14 in "Configuring the Client System."
2
After you have logged into the remote access portion of the system management
module, select one of the network switch modules.
• Type
connect switch-1
to connect to the top network switch module.
• Type
connect switch-2
to connect to the bottom network switch module.
3
To log on to the network switch module console, type:
Username-admin
Password-admin
You are logged into the switch console. By default, the switch is DHCP client-enabled.
4
To obtain the IP address of the network switch module, type
#sh ip interface.
RJ11 serial port for
network switch
module setup
link indicators (4)
activity indicators (4)
10/100/1000
BASE-T uplink
ports (4) system fault
indicator
reset button
0w440eb1.fm Page 8 Monday, October 28, 2002 2:23 PM