Dell P143G, Руководство по обслуживанию

Страница: 57 / 79

11. Connect the fan cable to the system board.
12. Connect the display cable to the connector on the system board and close the latch.
13. Adhere the tape that secures the display-cable connector latch to the system board.
14. Connect the power-adapter port cable to the system board,
15. Adhere the tape that covers the power-adapter cable-connector on the system board.
16. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
17. Replace the two screws (M2.5x5) that secure the right-display hinge to the system board.
Next steps
1. Install the heat sink .
2. Install the wireless card .
3. Install the memory .
4. Install the M.2 2280 solid-state drive .
5. Install the M.2 2230 solid-state drive .
6. Install the 3-cell battery or the 4-cell battery , whichever applicable.
7. Install the base cover .
8. Follow the procedure in After working inside your computer .
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the base cover .
3. Remove the 3-cell battery or the 4-cell battery , whichever applicable.
4. Remove the coin-cell battery .
5. Remove the M.2 2230 solid-state drive .
6. Remove the M.2 2280 solid-state drive .
7. Remove the wireless card .
8. Remove the power-adapter port .
9. Remove the I/O board .
10. Remove the speakers .
11. Remove the touchpad .
12. Remove the fan .
13. Remove the display assembly .
14. Remove the power-button with optional fingerprint reader .
15. Remove the system board .
NOTE: The system board can be removed with the heat sink and solid-state drives attached.
About this task
The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the
removal procedure.
Removing and installing components 57