Replacing the Display Assembly
1.
Align the display hinges with the holes in the base of the computer, then lower the display into place.
2.
Replace the two M2.5 x 5-mm screws that secure the display on the back of the computer.
3.
Connect the display cable to the system board.
4.
Connect the Mini-Card antenna cables (see
Replacing the Mini-Card
).
5.
Replace the keyboard (see
Replacing the Keyboard
).
6.
Replace the hinge cover (see
Replacing the Hinge Cover
).
7.
Close the display.
8.
Replace the two M2.5 x 5-mm screws (labeled "D") that secure the display on the bottom of the computer.
Display Bezel
Removing the Display Bezel
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Remove the hinge cover (see
Removing the Hinge Cover
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the display assembly (see
Removing the Display Assembly
).
1
display assembly
2
antenna cables (3)
3
display cable pull tab
NOTICE:
Ensure the antenna cables are not twisted and that they are lying flat in the antenna cable clip.
NOTICE:
Using the plastic tabs on the base of the computer, ensure that cables are properly routed and secured.
CAUTION:
Before you begin the following procedure, follow the safety instructions in the
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such
as the back panel on the computer.
