Installing the smart card cage
1
Slide the smart card cage into the slot to align with the screw holders on the computer.
2
Replace the 2 (M2 x 2.0) screws to secure the smart card cage to the computer.
3
Affix the thermal pad on the SSD module.
4
Affix the LED board cable and connect it to the LED board on the computer.
5
Affix the smart card cable and connect it to the USH board on the computer .
6
Install the:
a
b
c
d
e
NOTE:
To install both cards if equipped.
7
Follow the procedure in
After working inside your computer
.
Fingerprint Board
Removing the fingerprint reader board
1
Follow the procedure in
Before working inside your computer
.
2
Remove:
a
b
NOTE:
To remove both cards if equipped and no need to remove the blank filler
c
d
3
To remove the fingerprint reader board:
a Lift the coin cell battery affixed to the speaker cables [1].
b Disconnect the finger print reader cables from the fingerprint reader board and the USH board [2].
NOTE:
The cable should be released so that it does not tear.
c Remove 1(M2 x 3) screw that secures the fingerprint reader bracket to the computer [3].
d Lift the fingerprint reader bracket from the fingerprint reader board [4].
e Lift the fingerprint reader board from the slot on the computer.
NOTE:
Fingerprint reader board is affixed to the palm rest and you may need a plastic scribe to lift the fingerprint
reader board.
20
Removing and installing components