Back to Contents Page
Display
Dell™ Inspiron™ 1420/Dell Vostro™ 1400
Service Manual
Removing the Display Assembly
Replacing the Display Assembly
Removing the Display Bezel
Replacing the Display Bezel
Removing the Display Panel
Replacing the Display Panel
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the four M2.5 x 5-mm screws (one on each side of the main battery bay and one below each hinge cover) that connect the display assembly to
the computer.
3.
Remove the keyboard cover (see
Removing the Keyboard Cover
).
4.
Remove the keyboard (see
Removing the Keyboard
).
5.
Lift the cable securing tab for the camera module cable, and then gently pull the camera module cable from the connector.
6.
Using a plastic scribe, pry out the left and right hinge covers.
7.
Ensure that the display is opened all the way (150 degrees).
8.
Use the pull-tab to disconnect the display cable from the system board.
9.
Remove the Mini-Card antenna cables from the cards.
10.
Remove the Mini-Card antenna cables from the cable guide.
11.
Remove the screw from the media buttons board.
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as the back panel on the computer.
1
display cable pull-tab
2
Mini-Card antenna cables
Содержание Inspiron 1420
Страница 8: ...Back to Contents Page ...
Страница 21: ...Back to Contents Page ...
