Make sure that there is no exposed adhesive material between labels. Exposed areas
can cause labels to peel off during printing, which can cause paper jams. Exposed
adhesive can also cause damage to printer components.
Do not load a sheet of labels through the printer more than once. The adhesive
backing is designed for one pass through the printer.
Do not use labels that are separating from the backing sheet or are wrinkled, bubbled,
or otherwise damaged.
Use only labels recommended for laser printers.
For Card Stock or Custom-sized materials:
Postcards, 3.5 by 5.83 in.(index) cards and other custom-sized materials can be
printed with this printer. The minimum size is 3.0 by 5.0 in.(76 by 127 mm) and the
maximum size is 8.5 by 14 in.(216 by 356 mm).
Always insert the short-edge into the Manual Feeder first. If you want to print in
landscape mode, make this selection through your software. Inserting paper long-edge
first may cause a paper jam.
Do not print on media smaller than 3.0 in.(76 mm) wide or 5.0 in.(127 mm) long.
For preprinted paper:
Letterheads must be printed with heat-resistant ink that will not melt, vaporize, or
release hazardous emissions when subjected to the printer's fusing temperature of
205°C (400°F) for 0.1 second.
Ink on letterheads must be non-flammable and should not adversely affect printer
rollers.
Forms and letterheads should be sealed in a moisture-proof wrapping to prevent
changes during storage.
Before you load preprinted paper as forms and letterheads, verify that the ink on the
paper is dry. During the fusing process, wet ink can come off preprinted paper.
Do not use
Carbonless
paper and
Tracing
paper. Use of these types of paper could
result in chemical smells and could damage your printer.
Verifying the Output Location
The printer has a paper output tray that collects paper face-down, in print order.
