7.
Disconnect the Mini-Card antenna cables from the connectors on the Mini-Card. See
Removing the Mini-Card
.
8.
Make a note of the display cable and Mini-Card antenna cables routing and remove the cables from the routing guides.
9.
Remove the four screws (two on each side) that secure the display assembly to the computer base.
10.
Lift and remove the display assembly out of the computer base.
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.
3.
Route the display cable and Mini-Card antenna cables through the routing guides.
4.
Connect the Mini-Card antenna cables to the Mini-Card. See
Replacing the Mini-Card
.
5.
Connect the display cable to the connector on the system board.
6.
Replace the hinge cover. See
Replacing the Hinge Cover
.
7.
Follow the instructions from
step 3
to
step 7
in
Replacing the Palm-Rest Assembly
.
8.
Replace the two screws to the computer base.
9.
Replace the battery. See
Replacing the Battery
.
Display Bezel
Removing the Display Bezel
1.
Follow the instructions in
Before You Begin
.
2.
Remove the display assembly. See
Removing the Display Assembly
.
1
display cable
1 display assembly
2 screws (4)
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.