1
lever
5
card-edge connector
2
retention arm
6
card connector
3
filler bracket
7
riser board
4
card
8
card cage
Installing a Card
1. If you are installing a new card, remove the filler bracket to create an empty card-slot opening.
If you are replacing a card that is already installed in the computer, remove the card. If necessary, disconnect any
cables connected to the card. Grasp the card by its top corners, and ease it out of its connector.
2. Prepare the card for installation.
CAUTION:
Some network adapters automatically start the computer when they are connected to a
network. To guard against electrical shock, be sure to unplug your computer from its electrical outlet
before installing any cards.
3. Insert the card into the card connector.
If the card is full-length, insert the end of the card into the card guide bracket as you lower the card toward its
connector on the system board. Insert the card firmly into the card connector on the riser board.
4. Lower the retention arm and press it into place, securing the card(s) in the computer.
5. Replace the card cage:
a. Align the tabs in the side of the card cage with the slots on the side of the computer, and slide the card cage
down into place.
Содержание GX260 - Optiplex Pentium 4 2.0GHz 512MB 40GB CD
Страница 17: ......
Страница 64: ...Small Mini Tower Computer ...
Страница 80: ...15 Reconnect the 12 volt power cable to the 12VPOWER connector on the system board Back to Contents Page ...
Страница 87: ......