Dell Force10 TeraScale C Series, Справочное руководство

Страница: 16 / 1640

16 | CLI Basics
www.dell.com | support.dell.com
Multiple Configuration Users
When a user enters the CONFIGURATION mode and another user(s) is already in that configuration
mode, generates an alert warning message similar to the following:
Figure 2-2. Configuration Mode User Alert
When another user enters the CONFIGURATION mode, FTOS adds a message similar to the
following, where the user in this case is “admin” on vty2:
% Warning: User “admin” on line vty2 “172.16.1.210” is in configuration
Navigating the Command Line Interface
The Command Line Interface (CLI) prompt displayed by FTOS is comprised of:
• “hostname”— the initial part of the prompt, “FTOS” by default. You can change it with the
hostname command, as described in hostname .
• The second part of the prompt, reflecting the current CLI mode, as shown in Table 2-1 .
The CLI prompt changes as you move up and down the levels of the command structure. Table 2-1
lists the prompts and their corresponding command levels, called modes . Starting with the
CONFIGURATION mode, the command prompt adds modifiers to further identify the mode. The
command modes are explained in
Command Modes .
FTOS#conf
% Warning: The following users are currently configuring the system:
User "" on line console0
User "admin" on line vty0 ( 123.12.1.123 )
User "admin" on line vty1 ( 123.12.1.123 )
User "Irene" on line vty3 ( 123.12.1.321 )
FTOS(conf)#FTOS#
Note:
Some of the following modes are not available on C-Series or S-Series.
Table 2-1. Command Prompt and Corresponding Command Mode
Prompt CLI Command Mode
FTOS> EXEC
FTOS# EXEC Privilege
FTOS(conf)# CONFIGURATION