Dell EMC XC Core XC750xa, Инструкция по установке и обслуживанию

Страница: 127 / 144

3. If installing GPU other than T4 into front GPU riser module then, replace the GPU bracket .
4. If installing T4 GPU into front GPU riser module then, install the GPU riser module card holders .
5. install the GPU into front GPU riser module or install the GPU into expansion card riser.
NOTE: Mixing of different GPUs are not allowed.
NOTE: See Expansion card installation guidelines to know about risers and slots that support GPU.
NOTE: For information on riser slot location on the system board, see the System board jumpers and connectors topic.
6. If applicable, connect the power cables to the GPU. To know the connectors for GPU on the system board, see the
Expansion card installation guidelines topic.
NOTE: Refer to the GPU power cable matrix to know about the requirement of cable for the GPU.
Table 34. GPU power cable matrix
Categor
y
Description Type Vendor Cable Cable quantity Maximum per
system
GPU CRD,GRPHC,NVI
DIA,T4,16GB,70W
,L HH and HL (FH
and LP brackets) NVIDIA Not required Not required 6
GPU NVIDIA Volta
Next 300W DW
GPU (A100)-Gen
4 FH and FL NVIDIA 8 pin cable 1 piece per GPU
riser 4
GPU Nvidia RTX-A40 FH and FL NVIDIA 8 pin cable 1 piece per GPU
riser 4
HH - Half Height, HL - Half Length, FH - Full Height, FL - Full Length
7. Install the GPU riser module or expansion card riser . See GPU kit components table for supported GPU risers.
8. Install the air shroud .
After installing, follow the After working inside your system instructions.
Upgrade Kits 127