Edge 600 Series installation
To install the Edge 600 Series platform, complete the installation procedures in the order that is presented in this chapter.
Always handle the platform and components with care.
NOTE:
For thermal considerations, do not stack the Edge 600 Series platforms on top of each other.
NOTE:
ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap
when handling the platform and components. As with all electrical devices of this type, take all the necessary safety
precautions to prevent injury when installing this platform.
Topics:
•
•
•
•
•
•
•
Unpack
NOTE:
Before unpacking the platform, inspect the container and immediately report any evidence of damage.
When unpacking the platform, make sure that the following items are included:
•
One Dell EMC SD-WAN Edge 600 Series platform
•
MiniUSB console cable
•
Rubber feet for desktop use or wall-mount hardware
•
(Optional) dual rackmount tray
•
AC-to-DC power adapter
•
Dell EMC Edge 600 Series Quick Start Guide
•
Safety and Regulatory Information
•
Warranty and Support Information
1. Place the container on a clean, flat surface and cut all straps securing the container.
2. Open the container or remove the container top.
3. Carefully remove the appliance from the container and place it on a secure and clean surface.
4. Remove all packing material.
5. Inspect the product and accessories for damage.
Desktop mount
The Edge 600 Series includes four rubber pads that provide secure and stable placement of the platform on a clean, flat surface.
NOTE:
Ensure the platform is in a well-ventilated environment with clearance around the exhaust vents.
Wall mount
The Edge 600 Series includes wall mount installation hardware. You need a torque screwdriver to complete this installation.
4
Edge 600 Series installation
13
