System board
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted
to create a recovery key during program or System Setup. Be sure to create and safely store this recovery key.
If you replace this system board, you must supply the recovery key when you restart your system or program
before you can access the encrypted data on your drives.
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3. Remove the following components:
a.
b.
c.
d.
Processor and heat sink module
e.
f.
R1 and R3 paddle cards (if instlaled)
g.
h.
i.
j.
IDSDM module (if installed)
k. Internal USB card (if installed)
l.
m.
Serial COM port (if installed)
n. VGA port (if installed)
o.
p.
q. Disconnect all cables from the system board.
CAUTION:
Take care not to damage the system identification button while removing the system board
from the system.
Steps
1. Using the system board holder and plunger, slide the system board towards the front of the system.
2. Lift the system board out of the chassis.
Installing and removing system components
155
Содержание EMC Core XC750
Страница 1: ...Dell EMC Core XC750 Installation and Service Manual September 2021 Rev 1 0 ...
Страница 19: ...Figure 13 Service information Figure 14 Memory information and system board connectors System overview 19 ...
Страница 21: ...Figure 19 System tasks Figure 20 Heat sink Figure 21 BOSS S2 Figure 22 Express service tag System overview 21 ...
