Dell EMC Core XC750, Инструкция по установке и обслуживанию

Страница: 147 / 186

Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in Before working inside your system
3. Remove the expansion card risers .
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the guides on the intrusion switch module with the standoffs on the system.
2. Slide the intrusion switch module into the slot in the system until firmly seated.
3. Using a Phillips #1 screwdriver, tighten the screw on the intrusion switch module.
4. Connect the intrusion switch cable to the connector on the rear I/O board.
Figure 162. Installing the intrusion switch module
Next steps
1. Install the expansion card riser .
2. Follow the procedure listed in After working inside your system .
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
Installing and removing system components 147