Dell E75S Series, Инструкция по установке и обслуживанию, Страница: 82 / 133

3. Press the IDSDM module, until firmly seated on the system board connector.
Figure 73. Installing the IDSDM module
Next steps
1. Install the MicroSD cards .
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2. Follow the procedure listed in the After working inside your system .
Optional BOSS S2 card
Removing the BOSS S2 module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. If required, remove the air shroud .
Steps
1. Pull and lift the BOSS S2 card carrier retention latch lock to open.
2. Slide the BOSS S2 card carrier out.
82 Installing and removing system components