Dell E75S Series, Инструкция по установке и обслуживанию, Страница: 45 / 133

3. Lift the intrusion switch module out of the system.
Figure 32. Removing the intrusion switch module
Next steps
Replace the intrusion switch module .
Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in Before working inside your system .
3. Remove the air shroud .
4. Disconnect the system power cable from the system board.
Steps
1. Align and insert the intrusion switch module into the slot on the system until firmly seated.
2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the system board.
NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Installing and removing system components 45