Dell E75S Series, Инструкция по установке и обслуживанию, Страница: 68 / 133

Figure 59. Removing the retaining clip
Next steps
Replace the processor into a processor and heat sink module (PHM) .
Installing the processor into a processor and heat sink module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. Remove the air shroud .
4. Remove the processor heat sink module .
Steps
1. Place the processor in the processor tray with the connector side facing down.
NOTE: Ensure that the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
2. Place the retaining clip on top of the processor in the processor tray aligning pin 1 indicator on the processor.
NOTE: Ensure the pin 1 indicator on the retaining clip is aligned with the pin 1 indicator on the processor before placing
the retaining clip on the processor
NOTE: Before you install the heat sink, ensure to place the processor and retaining clip in the tray
68 Installing and removing system components