Figure 120. Installing a power supply unit
Next steps
1. If you have unlatched the cable management arm, relatch it. For information about the cable management arm, see the
system’s rack documentation at
2. Connect the power cable to the PSU, and plug the cable into a power outlet.
NOTE:
When connecting the power cable to the PSU, secure the cable to the PSU with the strap.
NOTE:
When installing, hot swapping, or hot adding a new PSU, wait for 15 seconds for the system to recognize the
PSU and determine its status. The PSU redundancy may not occur until discovery is complete. The PSU status indicator
turns green to indicate that the PSU is functioning properly.
NOTE:
While replacing the hot swappable PSU, after next server boot; the new PSU automatically updates to the same
firmware and configuration of the replaced one. For more information about the Part replacement configuration, see the
Lifecycle Controller User's Guide
at
https://www.dell.com/idracmanuals
Installing a power supply unit blank
Prerequisites
1. Follow the safety guidelines listed in the
on page 26.
2.
.
Steps
Align the PSU blank with the PSU bay and push it into the PSU bay until it clicks into place.
112
Installing and removing system components
