Figure 113. Installing the internal USB memory key
a. USB memory key
b. USB port
Next steps
1.
.
2. Follow the procedure listed in
After working inside your system
on page 27.
3. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Optional optical drive
Removing the optical drive
The procedure for removing an optical drive and optical drive blank is the same.
Prerequisites
1. Follow the safety guidelines listed in the
on page 26.
2. Follow the procedure listed in the
Before working inside your system
3. If installed,
.
.
5. Disconnect the power and data cables from the connectors on the optical drive.
NOTE:
Ensure that you note the routing of the power and data cable on the side of the system as you remove them
from the system board and drive. Route these cables properly when you replace them to prevent them from being
pinched or crimped.
Steps
1. Press the release tab to release the optical drive.
2. Slide the optical drive out of the optical drive slot.
106
Installing and removing system components
