Dell Dimension V333, Руководство по обслуживанию

Страница: 75 / 100

System Setup Program A-1
$ 3 3 ( 1 ' , ; $
6\VWHP6HWXS3URJUDP
This appendix describes the system setup program, which is used to change
the system configuration information stored in CMOS and NVRAM on the sys-
tem board.
To enter the system setup program, follow these steps:
1. Turn on (or reboot) the system.
2. When prompted to
Press <DEL> to enter SETUP
, press the <Del>key
immediately.
If you wait too long and the operating system begins to load into memory,
let the system complete the load operation. Then shut down the system and
try again.
NOTE: To ensure an orderly system shutdown, consult the documentation
that accompanied the operating system.
6\VWHP6HWXS6FUHHQV
The system setup program consists of a number of menus and submenus
with configuration options and information. The menu bar provides access to
the following six screens:
‡
Main screen — Provides settings for the basic system configuration
‡
Advanced screen — Provides detailed settings for some system features
‡
Security screen — Provides indications and settings for system password
and setup password
‡
Power screen — Provides settings for the system power-management
features
‡
Boot screen — Provides information about which device boots the system
‡
Exit screen — Provides selections for saving and loading the configura-
tions and options
In addition to these screens, options identified by a right arrow (see Figure A-2
for an example) provide access to submenus.