Dell Dimension V333, Руководство по обслуживанию

Страница: 70 / 100

4-26 Dell Dimension V xxx and V xxx c Systems Service Manual
6\VWHP%RDUG
)LJXUH 6\VWHP %RDUG 5HPRYDO
To remove the system board, follow these steps.
NOTES: Read this entire procedure before you begin.
If possible, print the system setup screens (by pressing the <Print Screen>
key) before you turn off the computer, because you will have to restore the
configuration information after the system board is replaced.
1. Disconnect any cables attached to the I/O panel on the back of the com-
puter (see Figure 4-24).
2. Remove the fan shroud as described in “Microprocessor and Heat Sink
Assembly.”
3. Remove any installed expansion cards.
Note the location of each connector and the orientation of any cables
attached to the expansion cards before disconnecting these cables.
4. Disconnect all internal cables from the system board.
The cables attached to the PRI IDE, SEC IDE, and FLOPPY connectors (see
Figure 4-18) each have two latches securing them to the system board.
Press the latch on each end of the cable connector, and pull to release the
cable from the system board.
The microprocessor and heat sink assembly (see Figure 4-22), the guide
bracket assembly, the expansion cards, and the DIMM modules must be
removed from the old system board and transferred to the replacement
secondary
hard-disk
drive bracket
system board
3.5-inch
diskette drive
I/O
gasket