Dell Color Laser Printer 2130cn, Руководство по обслуживанию

Страница: 266 / 900

1 - 240
Chapter 1 Troubleshooting
FIP-1. 46 Paper Jam 075-102
Step Check
Remedy
Yes No
Possible causative parts:
HARN ASSY L SIDE (PL3.1.18)
ROLL ASSY REGI (PL3.2.9)
ROLL REGI METAL (PL3.2.10)
SENSOR PHOTO (PL3.2.13)
ACTUATOR SSI (PL3.2.14)
SPRING REGI R M (PL3.2.24)
SPRING REGI L M (PL3.2.29)
PWBA MCU (PL8.2.13)
1 Was a paper pulled out from SSF forcibly of a print start? Go to step 2. Go to step 3.
2
Checking the printing
Reload a paper to SSF.
Does the error still occur when printing?
Go to step 3. End of work.
3
Checking after opening and closing the COVER ASSY
FRONT
Open and close the COVER ASSY FRONT, and then latch
correctly.
Does the error still occur when the power is turned OFF and
ON?
Go to step 4. End of work.
4
Checking the ROLL ASSY REGI and ROLL REGI METAL
for shape and operation
Remove the PHD ASSY once to check the followings.
Are ROLL ASSY REGI and ROLL REGI METAL seated
correctly?
Are they not contaminated and/or damaged, and rotated
smoothly?
Check these items by turning with your finger.
Go to step 5.
Clean or replace
the defective
ROLL(s).
5
Checking the ROLL ASSY REGI and ROLL REGI METAL
for contacting
Is the ROLL REGI METAL surely contacted with the ROLL
ASSY REGI by the spring force on both sides of the ROLL
REGI METAL?
Check this item with your finger.
Go to step 6.
Replace the
SPRING REGI R
M and/or SPRING
REGI L M.
6
Checking the ACTUATOR SSI for shape and operation
Remove the CHUTE LOW (PL3.2.27) once to check the
operation.
Are the shape and operation of the ACTUATOR SSI
normal?
Go to step 7.
Reseat the
ACTUATOR SSI.
If broken or
damaged, replace
the ACTUATOR
SSI.
7
Checking the SSF No Paper Sensor (SENSOR PHOTO) for
operation
Remove the CHUTE LOW (PL3.2.27) once to check the
operation.
Does the number on the screen increase by one, when the
actuator (ACTUATOR SSI) of the SSF No Paper Sensor
(SENSOR PHOTO) is operatred?
Checked by [Digital Input] - [DO-0] in [IOT Diag] of
diagnosis.
Replace the
PWBA MCU.
(Refer to Removal
43/ Replacement
11.)
Go to step 8.