Dell EMC PowerEdge C6420, Инструкция по установке и обслуживанию

Страница: 50 / 135

Steps
1 On the System Setup Main Menu screen, click System BIOS > Boot Settings > UEFI/BIOS Boot Settings > UEFI/BIOS Boot
Sequence .
2 Click UEFI/BIOS Boot Sequence
NOTE: Use the arrow keys to select a boot device, and use the plus (+) and minus (-) sign keys to move the device
down or up in the order.
3 Click Exit , and then click Yes to save the settings on exit.
Network Settings
You can use the Network Settings screen to modify UEFI PXE, iSCSI, and HTTP boot settings. The network settings option is available
only in the UEFI mode.
NOTE: BIOS does not control network settings in the BIOS mode. For the BIOS boot mode, the optional Boot ROM of the
network controllers handles the network settings.
Viewing Network Settings
To view the Network Settings screen, perform the following steps:
1 Power on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3 On the System Setup Main Menu screen, click System BIOS .
4 On the System BIOS screen, click Network Settings .
Network Settings screen details
The Network Settings screen details are explained as follows:
Option Description
UEFI PXE Settings
Options Description
PXE Device n (n =
1 to 4)
Enables or disables the device. When enabled, a UEFI PXE boot option is created for the
device.
PXE Device n
Settings
(n = 1 to 4)
Enables you to control the configuration of the PXE device.
Table 29. PXE Device n Settings screen details
Option Description
Interface Specifies the NIC interface used for this PXE device.
Protocol Enables you to select protocol IPv4 or IPv6 . This is set
to IPv4 by default.
VLAN Enables or Disable VLAN . This is set to Disabled by
default.
VLAN ID This is set to 1 .
50 Pre-operating system management applications