When the enclosure slides to the back of the cabinet, the rear tabs on the rails insert into the two notches in the rear of the
enclosure. The tabs secure and support the rear of the enclosure (
Rail tabs securing the rear of the enclosure
on page 26).
If the chassis does not slide all the way into the cabinet, you may need to further loosen the screws that hold the rear of the
rails in place, then adjust the rails to allow the tabs to fit into the notches.
CL4655
Figure 14. Rail tabs securing the rear of the enclosure
2. Once the enclosure is completely seated into the rear tabs, secure the enclosure, tighten the screws (two on each rail) that
secure the rails to the channels.
3. Secure the front of the enclosure to the front vertical channels with four screws (two per side), but do not tighten the
screws until they are all in place (
Securing the front of the enclosure
on page 26).
Rear
Front
Screw (2)
Screw (2)
CL4728
Figure 15. Securing the front of the enclosure
Install a DS60 shelf into the rack
Complete the following steps to install a DS60 expansion shelf.
CAUTION:
If the top of the shelf is installed above 32U high, a ladder is required to replace disk drives in DS60
shelves.
26
Install the Disk Shelves in the Rack
