4
Part Number: 9291472 05/18
DANGER
Installation must comply with all applicable fire and
health codes in your jurisdiction.
DANGER
Risk of fire/shock. All minimum clearances must be
maintained. Do not obstruct vents or openings.
DANGER
Use appropriate safety equipment during installation and
servicing.
DANGER
All utility connections and fixtures must be maintained in
accordance with local and national codes.
n
Warning
Remove all removable panels before lifting and installing.
n
Warning
Use caution when handling metal surface edges of all
equipment.
Location
n
Warning
Adequate means must be provided to limit the movement
of this appliance without depending on or transmitting
stress to the electrical conduit or gas lines.
n
Warning
To avoid instability the installation area must be capable
of supporting the combined weight of the equipment
and product. Additionally the equipment must be level
side to side and front to back.
n
Warning
This equipment is intended for indoor use only. Do not
install or operate this equipment in outdoor areas.
The location selected for the equipment must meet the
following criteria. If any of these criteria are not met, select
another location.
• Units are intended for indoor use only.
• The location MUST be level, stable and capable of
supporting the weight of the equipment.
• The location MUST be free from and clear of combustible
materials.
• Do not install near objects or surfaces affected by heat or
moisture.
• Equipment MUST be level both front to back and side to
side.
• Position the equipment so it will not tip or slide.
• Recommended air temperature is 41° - 86°F (5° - 30°C).
• Proper air supply for ventilation is REQUIRED AND
CRITICAL for safe and efficient operation. Refer to
Clearance Requirements chart on page 8.
• Do not install the equipment directly over a drain. Steam
rising up out of the drain will adversely affect operation,
air circulation, and damage electrical / electronic
components.
Weight of Equipment
Model
Weight
EHEI36
250lbs (113kg)
EHEI48
280lbs (127kg)
EHEI60
310lbs (141kg)
EHEI74
350lbs (159kg)
Clearance Requirements
DANGER
Minimum clearance requirements are the same for
noncombustible locations as for combustible locations.
The flooring under the appliance must be made of a
noncombustible material.
• The factory installed legs must be used and not removed.
Section 2
Installation