
V0608, 6.1
6.
Automatic mode
6.1.
Introduction
6.a
In the automatic mode a bend program can be executed automatically bend by bend after
pushing the ‘start’-key. When a new bending program is selected you must check your tools
and tool positions in your machine.
In the header information is displayed on the number of bends, the repetition of a bend, the
product number and the drawing number.
Above the horizontal line the programmed and computed parameters are displayed. See
chapter 2 about programming of these parameters.
The parameters below the horizontal line are corrections on the programmed values.
If the key lock is active, the program parameters (above the line) cannot be changed. The
correction parameters (below the line) can always be changed.
Use the key ‘change view’ to switch to another page with bend
parameters.
When this key is pressed again, a screen with zoomed values
appears.
Содержание DA-52
