Delem DA-52, Справочное руководство, Страница: 15 / 48

V0608, 2.5
2.3. Bend programming
2.3.1. Introduction
The parameters of one bend are divided over 2 screen pages. The bend number, product
number and drawing number are displayed in the top row on the screen.
2.d
The parameters below the line are corrections. They are not necessary when programming a
product, but are used to correct the machine behaviour during production. They are described
in chapter 6.
2.3.2. Bend parameters - first page
Method . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. BM
Select the required bending method. The control supports 2 methods:
0 = Air bend
1 = Bottoming
Bend methods:
Use the key ‘change view’ to switch to another page
with bend parameters.
When this key is pressed again, a screen with zoomed
values appears.