6
Fuse 2A
Fuse 5A
To car antenna
FM Modulator
To +12V ACC,
Speaker
DIN cable
(8pin)
DIN connection cord (6 pin)
WIRING
CD changer
FM Radio
FM Modulator
Display unit
RF output
(89.1MHz or
88.7MHz)
Antenna
socket
+12 volt Accessory/Switched
(ORANGE/WHITE STRIPE)
Connect this wire to a point which is energized when the
ignition switch is turned to the "ON" or "ACCESSORY"
position.
Display Unit
Ground (BLACK)
Screw this to a metal part of the vehicle. Clean connecting
area of paint, dirt, etc. Poor ground can cause damage
and affect playability.
+12 volt Constant (GREEN/WHITE STRIPE)
Connect this lead to the cable to which power is continu-
ously supplied and which has been passed through the
vehicle's fuse block.
INTERFERENCE ON 89.1 MHz
If a clear signal cannot be obtained on 89.1 MHz, change the position of
the frequency select switch on the back of the FM Modulator and tune the
radio to 88.7 MHz when using the CD changer.
Select a frequency before mounting the FM Modulator.
Radio sensitivity is slightly reduced when the FM Modulator is connected.
Installation of the FM Modulator:
Install the FM Modulator to the mounting surface
with the included tapping screws (M3 x 12).
Driver
(M3 x 12)
