Note
If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect the battery
cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation,
not to cause a short circuit.
Do not install the unit in the following locations.
Locations exposed to direct sunlight.
Where hot air is discharged from the car heater.
In areas subject to extreme temperatures.
Incorrect installation can cause the sound to "skip" when playing a disc.
Mount the unit firmly in place, using the supplied brackets and screws.
Be careful not to damage the car wiring.
Be sure to use the supplied screws.
Be careful not to snag any wires when tightening screws.
Do not use any of the screws that are part of the brake or steering system, to install the unit.
Install the unit as closely to vertically or horizontally as possible. If the unit must be inclined, the angle must be 15° or less.
Installation
Angle
Installation and inclination angle
15° max.
15° max.
Horizontal mounting
ID (Identity) Switch for 2nd CD Changer
Installation and Wiring Precautions
Vertical mounting
3
To prevent a short-circuit,
Be sure to turn off the ignition and remove the negative (-) battery cable, prior to installation.
Connect power wires last.
1
Changer Identity Switch
BEFORE INSTALLING THE UNIT
Transport Lock Screws
The mechanism in the CD changer is "locked" into place during shipment by the
transport screws. Be sure to remove the screws prior to installation.
Caution
After removing the transport lock screws, place the supplied seals over the screw
holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
When used with a compatible controller, an additional CD changer can be installed.
When an additional CD changer has been attached in this fashion, the ID switch is
used to indicate the number of each respective changer unit.
Changer Identity Switch
Do not use this switch if only 1 CD changer is being used.
Refer to the manual of the divider unit for further details on 2 changer operation.
7
6
5
4
3
2
