12
7.
M
OUNTING REAR CUTTING COMPONENT ON MAIN FRAME
a) Insert the hitches found on the front of the rear connecting frame. Insert the screws and lock them with
the nuts.
b) Insert the head holes of the
REAR END STROKE ROD "17"
into the forks found on the rear side of the
rear connecting frame. Insert the screws and lock them with nuts.
c) Insert the free ends of the rear end stroke rod into the forks on the upper side of the rear cutting
component. Insert the screws and lock them with nuts.
8.
F
INAL ASSEMBLING
a) Insert the end of the
SIDE HOMOKINETIC CARDAN JOINT "22"
, directioning it as in the diagram, in
the shaft located on the right side of the gear box mounted on the main frame. Insert the other end of the
cardan joint in the shaft of the angular gear box mounted on the right cutting component.
b) Repeat step "
a
" on the left side of the machine.
c) Insert the end of the
REAR HOMOKINETIC CARDAN JOINT "23"
, directioning it as in the diagram, in
the shaft located on the rear side of the gear box mounted on the main frame. Insert the other end of the
cardan joint in the shaft of the angular gear box mounted on the rear cutting component.
d) Position the
POWER DRIVING GROUP CARTER "25"
on the main frame. Insert the screws and lock
them with nuts.
9.
G
REASING AND LUBRICATION
In accordance with transportation regulations the machine comes without oil or grease. Therefore it must
greased and lubricated before using.
To do this see the section
"MAINTENANCE INSTRUCTIONS"
points
"1-2-3-4"
page 16 and 17.
