Dekema AUSTROMAT 624, Руководство по эксплуатации

Страница: 131 / 155

AUSTROMAT
®
624 / 644 7. Maintenance and Service
Operating Instructions (Version 01/2012) 131
ca. 25 mm
15 mm
1 2 3 4
Fig. 7-1 Evaluating the silver wire
1 Silver wire
2 Silver sample (bent silver wire)
3 Silver wire inserted into the middle of one-half of a DUCERA tray: Side view
4 Silver wire inserted into the middle of one-half of a DUCERA tray: Top view
3. Start the Temperature calibration program:
In the "Setup" menu, select the program "Temperature calibration", and press [Start] (see
section 5.7.3.3).
4. Evaluate the silver wire after the program using the following illustration.
1 2 3 4
Fig. 7-2 Evaluating the silver wire
1 Effective temperature too low: Increase CCF by approximately 5
2 Effective temperature okay
3 Effective temperature a bit too high: Lower CCF by approximately 3
4 Effective temperature too high: Lower CCF by approximately 5
5. Approach the correct setting of the CCF in small steps of approximately two to three points
(such as 1004 to 1006).
• By increasing the CCF, you increase the firing temperature,
•
By reducing the CCF, you lower the firing temperature.
Change the CCF
Observe the following procedure to change the CCF:
In the "Setup" menu, select the program "Temperature calibration", and enter a new CCF (see
section 5.7.3.3).
Minor corrections of the CCF can be made instinctively. If there are very large or sudden
deviations fro the original CCF, check for technical faults, and inform your service partner.