Degraf CONCEPT 501, Руководство пользователя

Страница: 11 / 27

TECHNICAL MANUAL
Technical Manual Eng. Version 3.1
Page 11 / 27
Warning: all available functions in this section should be accessed by trained and skilled
people only. Bad manipulation in this section may result in poor plate quality, damage of
the machine or safety risks.
Machine Setup :
•
Specific programs are available through the control panel.
•
To access to these parameter press , and the program number :
Note: Temperature calibration for one section of dryer always refers to 2 specific
programs: one for the lateral temperature (front and back of the drawer) and one for the
temperature in the middle of the drawer.
N° Password
needed : Function :
30
No Automatic switch OFF of the heating after the last drying time
36 No Set the temperature display to °F
37 No Set the temperature display to °C
55 No Display the software number
56
(see “ Note” )
Correction of the dryer 1 temperature in middle of the drawer
Before entering the new value, it is required to check the difference
between the temperature displayed and the temperature inside the
dryer. For example if the value displayed is 60°C and the
temperature inside is 56°C, 4 °C will have to be subtract from the
value displayed in P56 prior to re-enter the new value. Has to be
done when the dryer is in the regulation phase.
57
(see “ Note” )
Correction of the dryer 2 temperature in middle of the drawer
Before entering the new value, it is required to check the difference
between the temperature displayed and the temperature inside the
dryer. For example if the value displayed is 60°C and the
temperature inside is 56°C, 4 °C will have to be subtract from the
value displayed in P56 prior to re-enter the new value. Has to be
done when the dryer is in the regulation phase.
58
(see “ Note” )
Correction of the dryer 3 temperature in middle of the drawer
Before entering the new value, it is required to check the difference
between the temperature displayed and the temperature inside the
dryer. For example if the value displayed is 60°C and the
temperature inside is 56°C, 4 °C will have to be subtract from the
value displayed in P56 prior to re-enter the new value. Has to be
done when the dryer is in the regulation phase.