Page 9
•
To prevent flow of dirty water back into
the machine and to allow for easy
discharge, do not immerse the hose end
into the dirty water or do not push it in the
drain by more than 15 cm. If it is too long,
cut it shorter.
•
The end of the hose should not be bent, it
should not be stepped on and the hose
must not be pinched between the drain
and the machine.
•
If the length of the hose is too short, use it
by adding an original extension hose.
Length of the hose may not be longer
than 3.2 m. To avoid water leakage, the
connection between the extension hose
and the drain hose of the machine must
be properly fitted with an appropriate
clamp so as not to come off and leak.
•
The hose should be attached to a height
of at least 65 cm, and 100 cm at most.
•
In case the hose is elevated after laying it
on the floor level or close to the ground
(less than 65 cm above the ground), water
discharge becomes more difficult and the
laundry may come out excessively wet.
Therefore follow the heights as per the
following figure.
1. Unplug the machine before transporting it.
2. Remove the water drain and water supply
connections.
3. Drain all the water that has remained in
the machine.
4. Fit the polystyrene and then package the
machine.
Transportation of the machine
Using detergent /softener and bleach
When using detergent, softener,
starch, fabric dye, bleach or
limescale remover please ensure
you read the detergent
manufacturer's instructions on the
package carefully and follow the
suggested dosage values. Use
measuring cup if available.
Placing the rodent guard on the machine:
To place the rodent guard on the machine,
remove the screw as per the diagram below.
Place the rodent guard in position then
fasten the screw to secure the rodent guard
in place.
Adjusting the feet
Adjust the feet so that the machine is level
and balanced. A machine that is unlevelled
will vibrate, generate excessive noise,
damage the safety switch and may not
complete the spin function.
Adjust the 2 adjustable legs of the machine
by turning them either in a clockwise or anti
clockwise direction.
Rodent guard
(Depends on model)
A rodent guard is not supplied with the
machine. If required, a rodent guard may be
purchased from Defy spares.
