Page 8
Review information in the user manual and
ensure that the electricity, water supply and
water drainage systems are appropriate. If
they are not, call a qualified technician and
plumber to have any necessary
arrangements carried out.
Appropriate installation location
•
Place the machine on a rigid floor that has
sufficient load carrying capacity.
•
The machine height is only adjustable at
the front. The machine needs to be
orientated on a floor that is level on either
side and the back is either level or higher
than the front.
•
Choose a well ventilated dry location out
of direct sunlight.
•
Do not place the machine on the power
cable.
•
Do not install the machine at places where
the temperature may fall below 0ºC.
•
Place the machine at least 10 mm away
from the edges of other furniture.
•
Hot and cold water taps should be located
within 1 metre of the inlet valves.
Connecting the water supply
The water supply pressure required
to run the machine is between 1 to
10 bars (0 1 - 1 MPa).
It is necessary to have 10 - 80 litres
of water flowing from the fully open
tap per minute in order to have
your machine run smoothly. Attach
a pressure reducing valve if the
water pressure is higher.
If you are going to use the double
water inlet machine as a single
(cold) water-inlet unit, install the
supplied stopper to the hot water
valve before operating the machine
(Only applies to machines supplied
with a blind stopper for closing off
the hot water valve)
Installation
1. Connect the special hoses supplied with
the machine to the water inlets on the
machine. Red hose (left) (max hot water
temperature for the machine is 60 °C) is
for hot water inlet, blue hose (right) (max
25 °C) is for cold water inlet.
Warning:
Ensure that the cold
and hot water connections are
made correctly when installing the
machine to prevent your laundry
coming out hot at the end of the
washing process and wearing out.
2. Tighten all hose nuts by hand. Never use
a tool when tightening the nuts.
3. Open the taps completely after completing
the hose connection to check for water
leaks at the connection points. If any
leaks occur, turn off the tap and remove
the nut. Retighten the nut carefully after
checking the seal. To prevent water
leakages and damages caused by them,
keep the taps closed when the machine is
not in use.
Connecting to the drain
•
The end of the drain hose must be directly
connected to the wastewater drain or to
the washbasin.
Warning:
Flooding will occur if
the hose comes out of its housing
during water discharge. There is
risk of scalding due to high
washing temperatures! To prevent
this and to ensure smooth water
intake and discharge of the
machine, secure the end of the
discharge hose tightly so that it
cannot dislodge easily.
