
8 - EN
3. The other end of the drain hose can be
connected directly to the wastewater
drain or to the washbasin. The fitting
must always be secured in every type of
connection. Your house may flood if the
hose comes out of its housing during
water discharge.
Important:
• The hose should be attached to a height of
maximum 80 cm.
number of elbows as not to hinder
ventilation.
C
To prevent water accumulation in the hose,
make sure that it is not folded on the
floor.
B
The air ventilation hose should not be
connected to the chimney of a stove or a
fireplace.
B
Do not operate your machine at the same
time with heaters such as a coal or gas
stove. Airflow may cause the chimney to
flare up. Airflow may cause the chimney
to flare up.
Connection to water drain
(Products equipped with a
condenser);
In products equipped with a condenser unit
water accumulated during the drying cycle
collects in the water tank. You should drain
accumulated water after each drying cycle.
You can directly drain accumulated water
through the water drain hose supplied with the
machine instead of periodically draining the
water collected in the water tank.
Important:
• You must be careful not the pinch or bend
the hose.
• The end of the hose should not be bent,
it should not be stepped on and it must
not be folded between the drain and the
machine.
C
When you direct the water drain out,
“Water Tank” warning LED will light up at
the end of each program.
Connecting the water drain hose for
models with the water tank on top;
1. Remove the hose from the machine by
pulling it out by its end. Do not use any
tools to take out the hose. Attach the
drain hose adaptor to the end of this
hose.
2. Connect the special drain hose supplied
with the machine to the hose adaptor
fitting.