SOLID PLATE HOB
Plate controls
•
Select the heat level by turning the knob to the
required setting.
•
You may select any setting
•
1= warming
•
2-3 =simmering
•
4= cooking
•
5-6 = frying and boiling
An indicator light will glow when the plate is switched
on.
Caring for Solid Plates
•
Before using the plates for the first time, switch them on for about 4 minutes at the
highest setting. This allows the factory applied protective coating to burn in. Fumes
will be given off the plate during this operation but this is normal.
•
To prevent blotchy discolouration and corrosion, moisture from spatters and spills
should be cleaned off immediately.
•
To clean the plates, wipe them with a damp cloth or nylon pad. A little liquid
detergent may be used. Do not use metal scourers or sharp metal objects to clean the
plates.
•
After cleaning, dry the plates by switching them on for a short while.
To prevent rust, periodically apply some sewing machine oil or electrical hotplate polish -
available from Defy Service Centres. Extra attention is required in areas of high humidity
or in close proximity to the sea.
NOTE: THE WARRANTY DOES NOT COVER THE REPLACEMENT OR
REPAIR OF RUSTED OR CORRODED PLATES.
Recommendations
•
Use only good quality pots with a level base. An uneven base can prolong cooking
times and waste energy.
•
Use pots with a base diameter slightly larger than the plate. This will ensure even heat
distribution and prevent spillage from dripping onto and staining the hot plate.
•
Always cover the pot with a lid. This will conserve energy and minimise spillage.
•
Thermal shock could damage the plates. Do not put cold pots on very hot plates.