7
HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
□
If needed, gently grasp the lamp head (A), it can be
tilted down by 60°and upward by 30°. It also can
be panned out 90° and panned in 40°.
4
5
A
□
Hinge (4)
can pan the lights in and out.
Hinge (5) can tilt the lamps up and down.
Operation
1
Adjusting the Lamp Heads
Installation (continued)
□
Place the mounting plate (C) against the ceiling.
Mark the hole locations.
□
If mounting to a wooden surface like a deck, you
can install the mounting screws (AA) through
the mounting plate (C) and into the wood with a
screwdriver, or with a drill and bit driver.
You can also drill two pilot holes into the wood
mounting surface with a 1/8 inch drill bit and
then install the screws.
□
If mounting to wall board or brick, drill two pilot
holes into the mounting surface, using a 7/32
inch drill bit.
Insert the wall pegs (BB) and attach the mounting
plate (C) using the two mounting screws (AA)
with a very long Phillips screwdriver.
6
Installing the Mounting Plate
B. Eave or Ceiling Mount
7
Mounting the Light Fixture
□
Attach the light fixture (B) to the mounting
plate (C). Support the back-plate from behind
with one hand and push the light onto the
back-plate with the other hand.
□
Press the unit on the bottom to the mounting
plate (C). You should hear a “Click” sound.
This indicates that the device (B) is securely
attached to the mounting plate.
C
B
C
B
Click!
BB
C
AA
IQA HD-LB1895-IM-US-20180507B-FINAL.indd 7
28-May-18 9:18:23 AM
